HOW TO MEASURE TRAMPOLINE BEDS
for Octagon, Hexagon, Polygon sided trampoline frames

If your frame is assembled!
1. WITH A MEASURING TAPE THE FULL LENGTH (DIAMETER) OF YOUR TRAMPOLINE, MEASURE ACROSS FROM OUTSIDE FRAME TO OUTSIDE OF FRAME AT POINT TO POINT. NOTE THE EXACT INCHES. (The measurement of one leg post to the opposite leg post will help insure you are measuring across the middle of the trampoline.) THIS IS A 12 O'CLOCK TO A 6 O'CLOCK MEASUREMENT.

2. MEASURE AGAIN ACROSS THE MIDDLE, THE DIAMETER OF THE FRAME, BUT WITH A 9 O'CLOCK TO A 3 O'CLOCK MEASUREMENT. NOTE THE EXACT INCHES. (Do not round off or convert to feet and inches.)

3. IF YOU HAVE YOUR MAT (AND IT DOES NOT HAVE A TEAR); MEASURE JUST THE BLACK PART, OUTSIDE EDGE TO OUTSIDE EDGE AT POINT TO POINT. DO NOT INCLUDE THE TRIANGLES. MEASURE TWICE LIKE STEPS ONE AND TWO DESCRIBED. NOTE THE EXACT INCHES.

5. COUNT HOW MANY SPRINGS ARE ON THE ONE FLAT SIDE. (Note if there is a triangle at the point.)

4. COUNT HOW MANY SPRINGS IT TAKES TOTAL. COUNT HOW MANY SPRING HOLES IN THE FRAME FOR MORE ACCURACY. (Then count how many springs you have, in good condition, recoiled and with lots of tension. You may be missing springs or want more tension)

5. TAKE A SPRING OFF THE TRAMPOLINE & MEASURE IT INCLUDING THE HOOKS TO DETERMINE THE CORRECT LENGTH. (The spring coils must be fully recoiled to obtain the proper length).

6. HOW DO THE SPRINGS "HOOK" INTO THE MAT? TRIANGLES, GROMMETS, ETC..

7. HOW DO THE SPRINGS "HOOK" ONTO OR INTO THE FRAME?